What is the function and use of reamer ?

 
 What are the function and use of the reamer with the?

 As you know, the work of reamer is done to make a hole on an object, in this case, let us first know before using the work of reamer and on which object it is used and how it is used. Get to know a little about some pumps so that all of you will also get information about the pump, as well as give information about the scope of the reamer and safety precautions as to how it is used and who C. Safety precautions We must implement when using the reamer

 Let us first know a bit about the pump, what is the pump and whether it works:-

What is the pump?

A pump is a mechanical device used to move drinks from one point to another. The pumps operate by some section (continuous feedback or rotational) and are essentially consumed to perform the mechanical work that moves the liquid. All pumps operate with an electric motor that gives the life force for any fluid to move.

 What is the function of the pump?

• The function of the pump is to lift the weight of the liquid and provide attractive motion. With the goal that the liquid can be started from one location to the next. The higher the speed is the stream flow rate and therefore the less time required for transport. Anyway, we realize that head misfortune is directly proportional to the square of the current speed. It, therefore, requires the weight of the liquid at the outlet of the pump to defeat these misfortunes.

• The primary function of the pump is to lift the weight, not the speed of the liquid.

Now let us know what is the rimer and what is its use

What is a reamer? How does it work| What are the types of reamers?

The reamer is a cylindrical multi-fluid cutting tool that is used to finish the holes previously made by the drilling process. When a clue is made by drilling it is rough, so where the finished hole is needed Reamer is used. 

Reaming on wood with Reamer 

The process of finishing any hole by the reamer or increasing it slightly by size is called reaming. By this method, the hole can be made to a precision of + - 0.005. Metal can be cut from 0.02 to 0.15 mm by rimming. It is also known as Rimming Allowance.

 
Reamers

                 Reamers are usually made from high carbon steel or high-speed steel. And hard and temper. They have straight curved grooves on their body. For greater production, rims with carbo carbon tips are used. The angle of the chamfer is the main three angles of the body and sank reamer.

Types of Reamers?

There are usually two types of reamer: -

• hand reamer

• machine reamer

1. Hand reamer: - This type of reamer is used with the help of ranch or handle, it has a sank thread and equal spacing, on the upper end of it, there is a chakra tang, such a reamer is rotated with the strength of the hand. The following types of reamers are often used in workshops: - parallel reamer, taper reamer, adjustable reamer, expansion reamer, pilot reamer.

2. Machine Rear: - Machine reamer is also known as checking reamer. On this type of reamer, the taper sank remains. On which the flat teng is held, this rear is held in the machine's spinal and used. bridge reamers, machine jinge reamers.

Safety precautions to be taken while using the reamer

1. When using the reamer, the reamer should be placed at the right angle of the drill hole job.

2. While rimming in closed holes, the reamer must be kept out and out, repeatedly.

3. Proper lubricant should be used while reaming.

4. The reamer should never be reamed by fitting it into the machine spindle.

5. If the rimier is not to be used, it should be applied in a private place after applying oil.

 

Thanks for reading my blog

 Facebook:

 Tweeter: 

  Instagram: 

  linked in:

if you like this post kindly comment below the post and do share your response. thanks for reading: